NTSB finds flaws in gas-pipeline oversight

Associated Press

WASHINGTON

Three powerful accidents in recent years highlight weaknesses in the oversight of how natural-gas providers maintain the largest pipelines in their networks, accident investigators said Tuesday as they issued more than two dozen safety recommendations.

A major effort a decade ago by the federal government to check a rise in violent pipeline failures in “high-consequence” areas where people are more likely to be hurt or buildings destroyed has resulted in a slight leveling off of such incidents, but no decline, the National Transportation Safety Board said.

And though the frequency of such accidents remains low, they still are more likely to occur in more-densely populated areas despite increased safety efforts in those areas, the report found.

More safety improvements are needed “to prevent catastrophic gas transmission-line accidents from ever happening again,” said Chris Hart, the acting NTSB chairman.

A steady increase in pipeline explosions and fires in the 10 years prior to 2003 prompted the Pipeline and Hazardous Materials Safety Administration to adopt safety standards in 2004 for inspecting and maintaining the physical integrity of pipelines, with priority given to high consequence areas.

Since then, state-regulated pipelines — those that don’t cross state borders — have had a 27 percent higher incident rate than federally regulated pipelines that traverse more than one state, the report said.

From 2010 to 2013, incidents were overrepresented in high-consequence-area pipelines compared to less-developed areas where the risk to people and property is less, the board said.

Three accidents since 2010 illustrate many of the systemic problems, the board said. On Sept. 9, 2010, a massive section of pipeline was blown out of the ground, igniting a giant pillar of fire in San Bruno, a San Francisco suburb. Nine people were killed and 70 homes destroyed. The blast was so powerful that residents initially thought there had been an earthquake or jet crash. Because there were no automatic or remotely controlled valves, more than an hour passed before the gas could be shut off.

On Dec. 11, 2012, near Sissonville, W.Va., a stretch of pipeline ruptured, igniting a fire that destroyed three homes, damaged several others and melted the asphalt off a nearby stretch of highway. The pipeline hadn’t been inspected in 24 years.

A similar pipeline ruptured May 4, 2009, near Palm City, Fla. The blast tossed 106 feet of buried pipeline into the air. It landed in the right-of-way between two major highways — Interstate 95 and the Florida Turnpike. Incredibly, no fire was ignited even though 36 million cubic feet of gas escaped and two other large gas lines were buried parallel to the one that ruptured. One policeman was injured. Damage to the pipe’s protective coating had gone undiscovered, and a shut-off valve had failed to close.

In each of the accidents in the three states, the gas companies failed to conduct inspections or tests that might have revealed weaknesses in the massive pipelines, the NTSB found in a report that also reflected federal safety data and interviews with state inspectors and industry officials.

The concern then and now is that aging pipelines will rupture in populated areas. The U.S. is crisscrossed by nearly 300,000 miles of gas transmission pipelines, more than half of which were installed before 1970. The pre-1970 pipelines have a significantly higher failure rate because they have been exposed to environmental forces longer and newer pipelines have been made with improved safety technology, the board said.