ABCS FOR PROFIT FIT Measuring guide
There are a variety of methods for measuring bra size, but here's a rough approximation of the one used at Dillard's:
While wearing a bra, wrap a tape measure around your chest below the bust. Pull the tape until it is taut but not tight. Round that measurement to the nearest even number. That's your band size.
Now wrap the tape measure around the fullest part of your bust. If you are between whole numbers, round up to the nearest whole number. Now, subtract your even-numbered band size from Step 1 from the whole-numbered measurement in Step 2.
If the difference is less than an inch, you're an A cup; 1-2 inches, a B; 2-3, a C; 3-4, a D; 4-5 a DD; 5-6, a DDD or an E.
Here are some guidelines that will insure the proper fit:
The center section between the cups should lie flat on the chest.
Breasts should never bulge or spill out of the cups.
Bras should not leave lines or marks on the skin after prolonged wear.
If the band rides up your back, the band might be too loose.
If your bust is bulging under the cup, go up a cup size.
If straps dig into your shoulders, loosen the straps. If that doesn't work, try a larger cup size.
If straps fall off your shoulders, try a smaller band size. If you have sloped shoulders, try a racerback bra.
If the wire in your underwire bra is poking you, try a larger cup size.
McClatchy Tribune
43
